Computer quilting machine initial installation debugging（1）

Computerized quilting machine initial installation debugging

When the first according to the wiring diagram connect the full circuit, confirming circuit wiring is correct, then according to the following steps to start debugging:

1 saddle and roller motor wiring will not receive the first;

2 turn on the power, the starting up operation, into the "settings / test" picture;

The

3 observation "signal" bar;

4 are respectively the signal changes, such as the start, stop button can be pressed and released, observation shows that if there is a change, if it is close to switch, available metal
 close

Observing the display changes, if the switch is mechanical, the pressing and loose observation revealed changes, under normal circumstances the button without pressure or not feel should display "X

"Button is pressed down or feel, show" O ";

5 Computerized quilting machine if a signal is not normal, for external wiring problems, please carefully check the wiring, if all the signal

Abnormal, in addition to wiring problems, may refer to the fault checking method;

About 6 of the limit signal should ensure the correct position, the movable saddle motor to the right, the right limit signal should feel, show "O", then moved to
 frame motor

On the left, the left limit signal to be sensed, display "O";

7 check that the output signal;

8 click on the "brake signal" key, displayed in the "ON" and "OFF" between change, when "ON" is displayed, a brake clutch action should be, spindle lock, display "OFF

"When the clutch, brake action should be loosened, spindle;

The 9 remaining signal and similar;

10 "ON" converter "speed 1" "speed 2" "speed 3" used to observe the computer and transducer are connected to normal;

11 the first braking signal is set to OFF, to set up the "speed 1", "speed 2" "speed 3", then "converter.

News source: HengYeJiXie